search

Livorsi DTS Controls Instrukcja Użytkownika

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Czujniki Livorsi DTS Controls. Livorsi DTS Controls User Manual Instrukcja obsługi

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 18
  • Spis treści
  • BOOKMARKI
    • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 0
Livorsi DTS Controls- Single/Dual Engine Installation APRIL 2012 Page 1 of 12
715 Center Street
Grayslake IL 60030
P: 847-752-2700
F: 847-752-2415
E: info@livorsi.com
This document is written to aid our dealers, boat builders, and company service
personnel in the proper installation or service of our products. Persons who are not
familiar with these or similar products produced by Livorsi Marine, Inc., and who have
not been trained in the recommended servicing or installation procedures should have
the work performed by an authorized Mercury Marine dealer technician. Improper
installation or servicing of the Mercury Marine or Livorsi Marine product could result in
damage to the product or personal injury to the installer or persons operating the
product.
NOTICE
After completing installation, these instructions should be kept with the product for the
owner’s future use.
NOTICE
Notice to Personnel Installing this Kit
The installation of this product requires an installer who is specifically trained to work
on Mercury Marine’s or Livorsi Marine’s digital throttle and shift (DTS) systems. The
installer must be trained in the proper installation, electronic calibration, and operation
of the DTS system. Failure to correctly install this product may make this product and
/or the DTS system inoperable or unsafe for use.
Avoid possible injury or equipment damage. After installing this control, electronically
calibrate the digital throttle and shift (DTS) system. Do not attempt any calibration
unless you have been specifically trained in Mercury Marine’s DTS systems. Improper
electronic calibration of the DTS system will make this control and/or the DTS system
inoperable or unsafe.
CAUTION
Electrical Requirements
DTS equipped boats require that the electrical systems meet the following guidelines:
Use only marine starting batteries with a 1000 mca /800 cca/ 180 amp hour rating
or higher. Deep cycle batteries do not deliver the power required for the DTS
system.
Secure all battery cables with standard hex nuts, tightened to 13.5 Nm (120 lb. in.)
Do not use wing nuts, as they will not secure the battery cables properly.
Ensure that the battery cable size (cross section) meets the minimum size
requirements for the length of cable used. Refer to the installation manual supplied
with the engine.
Ensure that all power supply connections are clean and tight.
Livorsi DTS Controls
Single/Dual Engine Digital Throttle & Shift Installation
Przeglądanie stron 0
1 2 3 4 5 6 ... 17 18

Podsumowanie treści

Strona 1 - Livorsi DTS Controls

Livorsi DTS Controls- Single/Dual Engine Installation APRIL 2012 Page 1 of 12 715 Center Street Grayslake IL 60030 P: 847-752-2700 F: 847-752-2

Strona 2 - Dimensions and Clearances

Livorsi DTS Controls- Single/Dual Engine Installation APRIL 2012 Page 10 of 12 Control Connection Harness Connection Starboard Shift Potentiomete

Strona 3

Livorsi DTS Controls- Single/Dual Engine Installation APRIL 2012 Page 11 of 12 Control Quadrant Operation Shift Lever  Shift into reverse by mo

Strona 4 - Important:

Livorsi DTS Controls- Single/Dual Engine Installation APRIL 2012 Page 12 of 12 Aft Cant Models In-Handle Trim Switch 1. To tr

Strona 5

Livorsi DTS ControlArchitecture Drawing- Single EngineThe following information has been gathered from Mercury Marine and may not be current. Please c

Strona 6 - Neutral Safety Switch

Livorsi DTS ControlArchitecture Drawing-Dual EngineThe following information has been gathered from Mercury Marine and may not be current. Please cont

Strona 7 - Rigging the Control

(86 mm)3 3/8 in.Overall Surface AreaCutout Area(73 mm)2 7/8 in.Livorsi DTS Controls Flat BaseSingle Engine (2 handle)5 1/8 in. (130 mm)7 3/4 in. (1

Strona 8

(144 mm)Twin Engine 5 11/16 in.Overall Surface AreaCutout AreaTwin Engine 5 3/16 in. (131 mm)Livorsi DTS Controsl Flat BaseTwin Engine ( four handl

Strona 9

7 3/4 in. (197 mm)3 3/8 in. (86 mm)2 7/8 in. (73 mm)Livorsi DTS ControlsContour BaseSingle Engine (2 handle)When printing thistemplate, make sure t

Strona 10

7 3/4 in. (197 mm)5 3/16 in. (132 mm)5 11/16 in. (144 mm)Livorsi DTS ControlsContour BaseTwin Engine (4 handle)When printing thistemplate, make sur

Strona 11 - Throttle Lever

Livorsi DTS Controls- Single/Dual Engine Installation APRIL 2012 Page 2 of 12 Dimensions and Clearances Location Requirements Understand th

Strona 12 - Control Quadrant Maintenance

Livorsi DTS Controls- Single/Dual Engine Installation APRIL 2012 Page 3 of 12 Livorsi DTS Control Dimensions See cutout templates at the end of th

Strona 13 - Livorsi DTS Control

Livorsi DTS Controls- Single/Dual Engine Installation APRIL 2012 Page 4 of 12 Livorsi DTS Control Dimension Chart Number of Handles “A” DIM “B” D

Strona 14

Livorsi DTS Controls- Single/Dual Engine Installation APRIL 2012 Page 5 of 12 3. Use a #22 drill bit to drill the four required holes. Drill perpe

Strona 15

Livorsi DTS Controls- Single/Dual Engine Installation APRIL 2012 Page 6 of 12 Installing the Control to the Console 1. Secure the c

Strona 16

Livorsi DTS Controls- Single/Dual Engine Installation APRIL 2012 Page 7 of 12 Rigging the Control Connecting the SmartCraft Harness (Single Engine)

Strona 17

Livorsi DTS Controls- Single/Dual Engine Installation APRIL 2012 Page 8 of 12 1. Connect the “LEVER 1” connector on the DTS command module harnes

Strona 18

Livorsi DTS Controls- Single/Dual Engine Installation APRIL 2012 Page 9 of 12 Connecting the SmartCraft Harness (Dual Engine) The following proced

Więcej dokumentów dla Czujniki Livorsi DTS Controls

Aby wyświetlić dokument Livorsi DTS Controls Instrukcja Użytkownika
Livorsi DTS Controls Instrukcja Użytkownika (19 strony)

Komentarze do niniejszej Instrukcji

Brak uwag
Powiązane produkty i podręczniki dla Czujniki Livorsi DTS Controls
Czujniki Livorsi DTS Controls Instrukcja Użytkownika   (19 strony)
Czujniki Livorsi TTK1050EL Instrukcja Użytkownika   (11 strony)
Czujniki Livorsi LED Pop Up Bow Light Instrukcja Użytkownika   (2 strony)
  • Razberi Cub Cadet Aquverse MySN MicroBoards Technology
  • Sony Zewnętrzne dyski twarde Reliable Odkurzacze parowe Fusion Nie Hitachi Tablety graficzne Power Acoustik Subwoofery samochodowe
  • GE PEM31DFBB Electrolux EKC6450AOX Universal-security-instruments SS-770 Samsung DVD-VR300E Asus P5G41C-M
  • Samsung SC4325 Instrukcja Użytkownika Kidde 001860 Instrukcja Użytkownika Philips 223V7QHSB/01 Instrukcja Użytkownika Sharp PG-D40W3D Instrukcja Użytkownika Ricoh Aficio 1232C Instrukcje Operacyjne